Jul 24, 2012

7 Xerox WorkCentre admin mode.












You can reset the admin password by going into "Engineer Mode". 
Try one of these methods, and hopefully one will get you into Engineer Mode:

Press on the number you need :
Xerox Workcentre 5632

1. Once turned on hold # and key together.
2. Enter 1934 to go into diagnostic mode.
3. Diagnostic routines > other routines > 001 reset Auditron master pin.
Xerox Workcentre 7665

Press * and # and "red stop" keys (together!) to access diag tools.
Xerox Workcentre 7345

1. Hold 0 for 5 seconds
2. Press Start at the same time - should enter engineer mode
3. Password = 6789
4. Reset admin password (I can't remember the actual menu name)
5. If you need to exit engineer mode:
5.1. Hold 0 for 5 seconds
5.2 Press Start at the same time
Xerox Workcentre 5755,5735,5745,5765,5775

1. Press and hold the # key for 5 seconds, then press the Login key.
2. Enter the PIN code 1934
3. Touch the Enter button on the UI.



7 comments :

  1. I've figured out, how to enter Diagnostic mode (same as Tech Mode, as I understand):

    1. Turn on printer, until you get usual interface (with printing queue, scanning, copy tab, etc.).
    2. Press and hold "0" (zero digit) button fore more than 5 seconds.
    3. Press and release START button (the big green button).
    4. You'll be prompted to enter PIN - 6789.
    5. To EXIT go to the last tab, be sure, that Reset counters is UNCHECKED and hit Exit Only button.

    ReplyDelete
  2. when I turn on the machine workcentre 7328 I finished loading the software and if I touch any light button buttons simultaneously flashing.
    As I can enter diagnostic mode?
    Thank you
    My email is : coinme2015@gmail.com

    ReplyDelete
  3. I can`t help you, because I don`t have access anymore to this workcentre.
    If none of methods work, then you may need to call technician for a repair service.

    ReplyDelete
  4. How to enter service mode, on xerox á»­okcentre5755

    ReplyDelete
  5. Hi.
    Added info , how to access Xerox Workcentre 5755.
    Hope it helps :)

    ReplyDelete
  6. hello my dear friends I have xerox workcenter 5745 I have problem error comes replace xeroxgraphic module, when I asked support center , they says your machine is in diagonastic mode, remove from this mode then it works properly, but problem is that I don't know to how to get out from diagonastic mode any body help me please, I shall be thankfull to him/her

    Regards.
    Name: Arif Halili
    Email: halilicomputers@gmail.com

    ReplyDelete
  7. Hello friends, how to enter service mode on xerox 5325?
    Best Regard,

    ReplyDelete

Comment: